Abstract
Abstract We proposed a pixel-isolated liquid crystal (PILC) mode for enhancing mechanical stability of flexible display applications. Since the LC molecules in this mode are isolated in pixels by patterned or phase-separated microstructures, the LC alignment is stable against external pressure. Moreover, the cell gap of our structure is uniformly preserved against bending deformation of the plastic substrates since two substrates are tightly attached each other by the solidified polymer layer produced by photo-induced anisotropic phase separation. For flexible display applications, we have tested the mechanical stability of electro-optic properties in PILC structures with plastic substrates. 1. Introduction In recent years, roll-up displays have drawn considerable attention for next-generation information displays because of their excellent portability such as light weight, thin packaging, and flexibility. Among several available technologies, it is expected that a liquid crystal display (LCD) using plastic film substrates is the most promising device because of its superior visibility with low power consumption over other displays such as organic light-emitting device or electrophoretic displays. However, there are still critical problems regarding the fabrication of commercially available plastic LCDs with current technologies based on the glass substrates. One of those problems is the instability of LC structures due to hydrodynamic properties of LCs at bending and another is the separation of two plastic substrates due to the flexibility of film substrates. Such problems do not exist in conventional glass-substrate-based LCDs since glass substrates can sustain a stable LC alignment condition against external bending or pressure. To solve these problems, several types of polymer wall and/or network as supporting structures have been proposed and demonstrated [1]-[7]. These structures were fabricated using an anisotropic phase separation method from polymer and LC composite systems by applying a patterned electric field or spatially modulated UV intensity. However, these methods require high electric field to initiate the anisotropic phase separation or remain residual polymers in unexposed regions that reduce optical properties and increase the operating voltage of the devices.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.