Abstract
This paper proposes a new type of Hybrid (HB) magnetic bearings which has permanent magnet (PM) within the stator. It is intended for a magnetic bearing to have high efficiency, good dynamic response and low cost. HB magnetic bearing is recognized as an efficient one. But the bias PMs should be installed between the radial magnetic bearings. It requires thick magnetic circuit and produces flux leakage. Hence a new magnetic bearing is proposed based on the HB type. The bias PMs are installed inside the radial magnetic bearing. Hence all the magnetic circuit is closed inside the radial magnetic bearing and it is relatively free from the flux leakage. This magnetic bearing system is controlled using the hall diode as a position sensor which locates on the top of PMs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Proceedings of the Dynamics & Design Conference
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
