Abstract

The paper presents design and verification of regression models for prediction of pipe conveyor belt contact forces on idler rolls. Their advantage is in the fact that they have been created according to the real experimental measurement. The obtained models correspond with real operational conditions. The concept of the experimental rig at the Technical University of Košice is designed so that it represents 8 m long section of pipe conveyor. The conveyor belt is an object with action of tension force and at the same time it takes the initiative in the contact force formation. Several criteria have been used to verify the presented regression models. The tensioning force 9000, 12,000 and 15,000 N have MPE of prediction error less than 5%. About 120,000 measured values have been processed during the evaluations which correspond to approximately 15,000 results from experimental measurements.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.