Abstract

The best way to investigate the tension softening process is by applying a uniaxial tension force directly on a concrete specimen, because it can measure both tensile strength and the tension softening curve from an identical specimen. However, no standard tests have been adopted to provide a direct measurement of the tension softening curves of concrete, though many inadequate test procedures were proposed until recently. There are four misunderstandings in investigating the tension softening process, concerning the effects of notches, secondary flexure, boundary conditions and specimen geometry. In this paper, the misunderstandings are discussed and clarified in detail with theoretical and experimental considerations. A test procedure free from these misunderstandings is proposed for the uniaxial tension test of concrete and some successful test results are presented.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.