Abstract
A new methodology for the development of miniature photoacoustic trace gas sensors using 3D printing is presented. A near-infrared distributed feedback (DFB) laser is used together with a polymer-based gas cell, off-the-shelf fiber optic collimators, and a microelectromechanical system (MEMS) microphone to measure acetylene at 1532.83 nm. The resonance behavior of the miniature gas cell is analyzed using a theoretical and experimental approach, with a measured resonance frequency of 15.25 kHz and a Q-factor of 15. A minimum normalized noise equivalent absorption of 4.5×10(-9) W cm(-1) Hz(-1/2) is shown together with a 3σ detection limit of 750 parts per billion (ppb) for signal averaging times of 35 s. The fiber-coupled delivery and miniature cost-effective cell design allows for use in multipoint and remote detection applications.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
