3D printing of microfluidic devices with embedded sensing electrodes for generating and measuring the size of microdroplets based on contactless conductivity detection

Abstract

This report describes the 3D printing of integrated microfluidic platforms containing microchannels and embedded sensing electrodes for capacitively coupled contactless conductivity detection (C4D). Sensing electrodes were printed on poly(lactic acid) filament doped with carbon nanotubes and then integrated with fluidic channels printed on acrylonitrile butadiene styrene. The proposed microfluidic chips were explored to generate and measure the size of microdroplets based on C4D measurements. To the best of our knowledge, this is the first report showing the entire fabrication of an integrated platform by 3D printing as well as its use for measuring the size of droplets. The proof-of-concept was successfully demonstrated by generating oil droplets in an aqueous phase and water droplets in an oil phase. The droplet sizes were estimated based on their residence time within the detection cell in association with the flow velocity. According to the data achieved by C4D measurements, the length of water droplets decreased from 3.4±0.1 to 2.3±0.1mm when the total flow rate raised from 15 to 55μLmin−1. For oil droplets, length values ranged from 3.6±0.1 to 2.4±0.1mm at the same flow rate range. The achieved results exhibited an exponential correlation with the data obtained by optical measurements.