3D printing in oral and maxillofacial surgery: a nationwide survey among university and non-university hospitals and private practices in Germany.

Abstract

Oral and maxillofacial surgery (OMFS) has undergone pioneering progress through the development of three-dimensional (3D) printing technologies. The aim of this study was to evaluate the use of 3D printing at OMFS university and non-university hospitals and private practices in Germany. For explorative assessment, a dynamic online questionnaire containing 10-22 questions about the current use of 3D printing and the reasons behind it was sent to OMFS university and non-university hospitals and private practices in Germany by the study group from the German Association of Oral and Maxillofacial Surgery (DGMKG). In total, 156 participants responded from university (23 [14.7%]) and non-university hospitals (19 [12.2%]) and private practices without (85 [50.5%]) and with 29 (18.6%) inpatient treatment facility. Highest applications of 3D printing were in implantology (57%), microvascular bone reconstructions (25.6%), and orthognathics (21.1%). Among the participants, 37.8% reportedly were not using 3D printing. Among the hospitals and private practices, 21.1% had their own 3D printer, and 2.5% shared it with other departments. The major reason for not having a 3D printer was poor cost efficiency (37.6%). Possessing a 3D printer was motivated by independence from external providers (91.3%) and rapid template production (82.6%). The preferred printing methods were stereolithography (69.4 %) and filament printing (44.4%). OMFS 3D printing is established in Germany with a wide range of applications. The prevalence of 3D printing in hospitals and private practices is moderate. This may be enhanced by future innovations including improved cost efficiency.