3D printing for chest wall reconstructive surgery

Abstract

PurposeThe purpose of the paper was to present a specific case study of how 3D printing was introduced in the chest wall construction process of a specific patient with unique medical condition. A life-size 3D model of the patient’s chest wall was 3D printed for pre-surgical planning. The intent was to eliminate the need for operative exposure to map the pathological area. The model was used for preoperative visualization and formation of a 1-mm thick titanium plate implant, which was placed in the patient during chest wall reconstructive surgery. The purpose of the surgery was to relive debilitating chronic pain due to right scapular entrapment.Design/methodology/approachThe patient was born with a twisted spine. Over time, it progressed to severe and debilitating scoliosis, which required the use of a thoracic brace. Computerized tomography (CT) data were converted to a 3D printed model. The model was used to size and form a 1-mm thick titanium plate implant. It was also used to determine the ideal location for placement of the plate during thoracotomy preoperatively.FindingsThe surgery, aided by the model, was successful and resulted in a significantly smaller incision. The techniques reduced invasiveness and enabled the doctors to conduct the procedure efficiently and decreased surgery time. The patient experienced relief of the chronic debilitating pain and no longer need the thoracic brace.Originality/valueThe 3D model facilitated pre-operative planning and modeling of the implant. It also enabled accurate incision locations of the thoracotomy site and placement of the implant. Although chest wall reconstruction surgeries have been undertaken, this paper documents a specific case study of chest wall construction fora specific patient with unique pathological conditions.