3D printing and dynamic modeling of a polymer-based bimodal piezoelectric motor

Abstract

Owing to characteristics of single-step fabrication and rapid prototyping, 3D printing have potential applications in processing piezoelectric motors with complex structures. In this paper, a 3D printed resin-based bimodal piezoelectric motor is proposed. Four slots of the motor are designed to reduce the influence of large damping caused by polymer’s viscoelastic and enhance mechanical properties. Considering the viscoelasticity and internal structure of the stator, a dynamic model based on the proposed motor is developed. Furthermore, parameters of these slots are optimized using the Taguchi method. Prototypes are fabricated and experimentally investigated. The results demonstrate that the first longitudinal mode and the second bending mode are 17 765 Hz and 18 006 Hz respectively, which are consistent with the analytical model results. Under the voltage of 300 Vpp, the maximum no-load speed and maximum driving load of the slotted motor are 200 r min−1 and 20 g with a speed of 6 r min−1, respectively. Compared with the motor without slots, the speed and load capacity are increased by 25% and 33%. Therefore, the motor with slots exhibits better mechanical output performance.