Abstract
PurposeThis study aims to examine the efficacy of 3D printing polymers to realistically mimic the fossa ovalis (FO) – a cardiac structure that is positioned in the interatrial septum – for simulating transseptal puncture (TP) procedures.Design/methodology/approachSpecimen of different materials and thicknesses were prepared and tested simulating the puncturing of the FO using a 12F ID/14F OD TP catheter. Force and tenting length results were compared with literature references. Scanning electron microscope images of the specimen were acquired to observe the perforated region as well as the structure of the specimen in the unaffected area.FindingsSignificant changes in the properties of interest were registered for the same material on specimens tested at different moments after fabrication. Suturable vessel wall polyjet material offers the best characteristics to replicate FO anatomy and mimic its behavior to puncturing.Originality/valueThe originality of the work lies in the test of different commercial materials. Similar works are already present in literature but specifically designed materials are used. Demonstrating that off-the-shelf materials could be viable for FO specimens would simplify the design of realistic TP simulators in the future.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
