3D-printed pelvis model is an efficient method of osteotomy simulation for the treatment of developmental dysplasia of the hip.

Abstract

Developmental dysplasia of the hip (DDH) is a congenital or developmental deformation of the hip joint, which may require a high number of surgical interventions. It has been indicated that 3D printing may be used to simulate a fractured pelvis to facilitate the fixation of plates during the surgical procedure. In the present double-blinded randomized clinical trial, the utility of the 3D-printed pelvis model, comprising 3D reconstruction, reverse engineering and rapid prototyping, in the treatment of DDH was evaluated with 3D CT as control. The value of the 3D-printed pelvis model in the surgical management and development of a strategy for an individualized operation for DDH using osteotomy simulation was also assessed. The results indicated that use of the 3D-printed pelvis model increased the success rate of the operation with a shortened surgery time and post-operative recovery time for DDH patients. In addition, the application of the 3D-printed pelvis model allowed for more efficient surgical management of DDH than 3D CT and promoted post-operative recovery of the DDH patients. Pre-operative planning using the 3D-printed pelvis model was feasible for DDH patients. Furthermore, few patients exhibited delayed incision healing, wound infection or nonunion in the DDH group with osteotomy simulation using the 3D-printed pelvis model or 3D-CT. In conclusion, the present study indicated that the 3D-printed pelvis model, including 3D reconstruction, reverse engineering and rapid prototyping, constitutes an efficient tool for pelvic osteotomy simulation, which improves personalized pre-operative planning by providing a visual and accurate osteotomy model for patients with DDH (Chinese Trial Registry No. KCT0012374).