3D printable carbon nanotubes-based composites with reconfigurable shapes and properties

Abstract

In this work, we developed an efficient approach to fabricating composites of carbon nanotubes (CNT) with shape reconfiguration ability and Joule heating behavior by incorporating the direct ink writing (DIW) technique. Our 3D printable ink consisted of a high concentration of CNT stabilized by polyvinylpyrrolidone (PVP) in an aqueous polyvinyl alcohol (PVA) solution. The rheology of the ink was tuned by the amounts of CNT and PVP. The printed objects underwent the freeze-thaw process to form weak hydrogels induced by the crystallization of PVA. Subsequently, the hydrogels were immersed in a deep eutectic solvent (DES) bath consisting of choline chloride and glycerol. This process replaced the water in the hydrogels with DES and led to mechanically tough DES/CNT gels. We utilized the high stretchability of DES/CNT gel to achieve complex geometries that would be challenging to accomplish solely with DIW. After reshaping the DES/CNT gels, the target shape was fixed by further solvent exchange with ethanol and drying. The final CNT composites showed a high electric conductivity of up to 33.94 S/m and exhibited remarkable Joule heating performance using a low applied voltage (5 V). Additionally, we successfully achieved a spatial variation of mechanical stiffness, electrical conductivity, and Joule heating across the printed objects by a selective solvent removal process. In short, this work expands the scope of possible shapes and properties of CNT-based composites.