3D photonic crystal intermediate reflector for micromorph thin‐film tandem solar cell

Abstract

AbstractThe concept of 3D photonic intermediate reflectors for micromorph silicon tandem solar cells has been investigated. In thin‐film silicon tandem solar cells consisting of amorphous and microcrystalline silicon with two junctions of a‐Si/μc‐Si, efficiency enhancements can be achieved by increasing the current density in the a‐Si top cell. It is one goal to provide an optimized current matching at high current densities. For an ideal photon‐management between top and bottom cell, a spectrally selective intermediate reflective layer (IRL) is necessary, which is less dependent of the angle of incidence than state‐of‐the‐art thickness dependent massive interlayers. The design, preparation and characterization of a 3D photonic thin‐film filter device for this purpose has been pursued straight forward in simulation and experimental realization. The inverted opal is capable of providing a suitable optical band stop with high reflectance and the necessary long wavelength transmittance as well and provides further options for improved light trapping. We have determined numerically the relative efficiency enhancement of an a‐Si/μc‐Si tandem solar cell using a conductive 3D‐photonic crystal. We have further fabricated such structures by ZnO‐replication of polymeric opals using chemical vapour deposition and atomic layer deposition techniques and present the results of their characterization. Thin film photonic IRL have been prepared at the rear side of a‐Si solar cells. Completed with a back contact, this is the first step to integrate this novel technology into an a‐Si/μc‐Si tandem solar cell process. The spectral response of the cell is presented and compared with reference cells. (© 2008 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)