Abstract
The present work aims at numerical approximation in combination with experimental validation of some of the important performance measures in turning of commercially pure titanium (CP-Ti) with uncoated carbide inserts. A three-dimensional (3D) finite element model was developed based on Lagrangian criterion. Simulation of the turning operation was performed using DEFORM 3D software in order to approximate the responses viz. feed force ([Formula: see text], radial force ([Formula: see text], tangential force ([Formula: see text], flank wear (Vb) and machining temperature ([Formula: see text]. Usui’s tool wear model was used to predict the flank wear. Morphology of the free and back surfaces of the chips was examined under a field emission electron microscope (FESEM). Turning experiments were carried out on a heavy duty lathe equipped with a 3D dynamometer. Secondly, a quadratic model was acquired for all the aforementioned quality characteristics using response surface methodology (RSM). Analysis of variance (ANOVA) test was performed to confirm the adequacy of the developed quadratic model. The results obtained from simulation and quadratic model were compared with the experimental data sets. Finally, an error analysis was done to determine the percentage inaccuracy of both the models. The percentage error for all the turning responses, was observed within 6% which showed the satisfactoriness of the proposed approximation tools. However, the simulation model exhibited lower prediction error when compared with the quadratic counterpart.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.