Abstract
This paper presents three-dimensional (3D) models of high-frequency piezoelectric micromachined ultrasonic transducers (PMUTs) based on the finite element method (FEM). These models are verified with fabricated aluminum nitride (AlN)-based PMUT arrays. The 3D numerical model consists of a sandwiched piezoelectric structure, a silicon passive layer, and a silicon substrate with a cavity. Two types of parameters are simulated with periodic boundary conditions: (1) the resonant frequencies and mode shapes of PMUT, and (2) the electrical impedance and acoustic field of PMUT loaded with air and water. The resonant frequencies and mode shapes of an electrically connected PMUT array are obtained with a laser Doppler vibrometer (LDV). The first resonant frequency difference between 3D FEM simulation and the measurement for a 16-MHz PMUT is reasonably within 6%, which is just one-third of that between the analytical method and the measurement. The electrical impedance of the PMUT array measured in air and water is consistent with the simulation results. The 3D model is suitable for predicting electrical and acoustic performance and, thus, optimizing the structure of high-frequency PMUTs. It also has good potential to analyze the transmission and reception performances of a PMUT array for future compact ultrasonic systems.
Highlights
Ultrasonic transducers have been widely used for medical imaging [1], nondestructive testing [2], rangefinders [3], gesture recognition [4], fingerprint systems [5], etc
The fabricated piezoelectric micromachined ultrasonic transducers (PMUTs) arrays, which can be seen in Comparison of Analytical Method, finite element method (FEM), and Experimental Results
Four PMUT arrays with different radii are fabricated on the same wafer using aluminum nitride (AlN) micromachined processes
Summary
Ultrasonic transducers have been widely used for medical imaging [1], nondestructive testing [2], rangefinders [3], gesture recognition [4], fingerprint systems [5], etc. Ultrasonic transducers based on piezoelectric ceramics [10] are bulky, lead-containing and low-frequency limited. They are not suitable for 2D arrays because of the poor consistency among the elements. Micro-machined ultrasonic transducers (MUTs) fabricated in MEMS have shown good consistency in miniaturized geometric structures. MUTs are suitable to realize high-frequency phased arrays for compact ultrasonic systems. Compared with a capacitive MUT (CMUT), a piezoelectric MUT (PMUT) has the advantages of no DC bias, a linear relationship between
Sign-in/Register to view highlights & summary 
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
