3D DEWS digital parametric modeling and manufacturing for obtaining the post-cracking parameters of SFRC

Abstract

A pullout analytical model is introduced to simulate the Double Edge Wedge Splitting (DEWS) test to obtain the tensile post-peak response of steel fiber reinforced concretes. One of the main barriers to the widespread utilization of FRC as a structural system is the anisotropy of the material. This augments the uncertainty of the material behavior (fibers random distribution and orientation in the bulk concrete), increases the dispersion of the test results, and requires the performance of characterization tests to check the residual tensile stresses at specific crack opening intervals. The characterization tests proposed in the literature (e.g., Barcelona, Montevideo, Wedge Splitting Test, EN 14651) are time-consuming and relatively complex, demanding careful preparation and hydraulic presses with data acquisition systems. This paper aims to contribute to the discussion of alternatives for FRC characterization procedures by the introduction of a pullout analytical model to predict FRC constitutive law based on DEWS tests. The pullout analytical model is calibrated with pullout tests considering straight and hooked-end steel fibers with different strengths, embedment lengths, inclinations, and diameters. A 3D digital model reproducing the experimental DEWS samples is developed, considering the fibers’ randomness distribution, orientation, and wall effect. The analyses are compared with four different experimental tests. The results define a linear post-peak tensile constitutive law, considering the mean residual stress values at different COD values. The model was able to reproduce the specimens’ production procedures and the fibers’ distribution and orientation correctly. The results demonstrated a good agreement with the experimental data.