Abstract
Layer‐by‐layer additive manufacturing (AM) by means of laser‐powder bed fusion (L‐PBF) offers many prospects regarding the design of lattice structures used, for example, in gas turbines. However, defects such as bulk porosity, surface roughness, and re‐entrant features are exacerbated in nonvertical structures, such as tilted struts. The characterization and quantification of these kinds of defects are essential for the correct estimation of fracture and fatigue properties. Herein, cylindrical struts fabricated by L‐PBF are investigated by means of X‐ray computed tomography (XCT), with the aim of casting light on the dependence of the three kinds of defects (bulk porosity, surface roughness, and re‐entrant features) on the build angle. Innovative analysis methods are proposed to correlate shape and position of pores, to determine the angular‐resolved surface roughness, and to quantify the amount of re‐entrant surface features, q. A meshing of the XCT surface enables the correlation of q with the classical surface roughness P a. This analysis leads to the conclusion that there is a linear correlation between q and P a. However, it is conjectured that there must be a threshold of surface roughness, below which no re‐entrant features can be build.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.