Abstract
Many studies have reported on the application and clinical efficiency of full arch maxillary dentition intrusion mechanics; however, studies about biomechanical effects such as stress, strain, and displacements on the teeth and the surrounding tissues are limited. The objectives of study was to evaluate and compare the stress distribution and displacement of total maxillary dentition under intrusion mechanics using a three-dimensional finite element analysisA three-dimensional finite element model was constructed based on computed tomography scan data, and it served basic model. The geometric model was converted to finite element model using Altair HyperMesh software. Model A with pre-adjusted edgewise appliance (PEA) setup and Model B with occlusal Splint setup was evaluated and compared for von mises stress distribution and displacement of total (full arch) maxillary dentition by using three dimensional finite element analysis; with force delivered from infrazygomatic screws and miniscrew. Force levels for Model A and Model B includes a total of 300grams of intrusive force (each side) on maxillary posterior segment from IZC bone screw and 100grams of intrusive force on anterior segment from miniscrew.In the model A; with PEA setup reinforced with two trans-palatal arches, highest von Mises stress of 0.970 Mpa was produced on second molar roots followed by molar roots and premolars and central and lateral incisors roots. In the Model A, maximum intrusive values was seen on crown tip of central and lateral incisors (8.671µm), and lowest displacement values on second molars (2.230µm). Similar pattern of von Mises stress distribution and displacement was observed in the Model B. Model A and Model B provided an effective en masse vertical control of the full arch maxillary dentition. Higher intrusion displacement values were seen in anterior segment than the posterior segments
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IP Indian Journal of Orthodontics and Dentofacial Research
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
