3D-2D microleakage assessment of preheated bulk-fill composite resin applied with different parameters: a micro-CT analysis.

Abstract

This study evaluated microleakage from class II cavities filled with bulk-fill composite preheated to different temperatures, applied at different thicknesses, and with different polymerization modes. A total of 60 mesio-occlusal cavity were drilled into the extracted human third molars at 2mm and 4mm thickness. Preheated bulk-fill composite resin (Viscalor; VOCO, Germany) was applied to the cavities at 68°C and 37°C after the adhesive resin was applied, and cured using standard and high-power light-curing modes of a VALO light-curing unit. An incrementally applied microhybrid composite was used as the control. The teeth were subjected to 2000 cycles of heating to 55°C and cooling to 5°C with a 30-s hold time. Then, they were immersed in a 50% silver nitrate solution for 24h and scanned with micro-computed tomography. Scanned data were processed using the CTAn software. Two (2D) and three (3D) dimensional analyses of leached silver nitrate were performed. The data's normality was assessed using the Shapiro-Wilk test before comparisons using a three-way analysis of variance. In both 2D and 3D analysis, bulk-fill composite resin preheated to 68°C and applied at 2mm thickness showed less microleakage. In the 3D analysis, restorations applied at 37°C and 4mm thickness in high-power mode showed significantly higher values (p < 0.001). Preheated bulk-fill composite resin can be applied at 68°C and effectively cured at both 2mm and 4mm thickness.