Abstract
In case of the five-axis controlled machining, the machine structure, such as table, spindle, and column, can take various positions and postures. So, the interference among machine structures may occur. However, in the commercial CAM software cooping with five-axis controlled machining, the structure interference is not considered. Therefore, the output cutter location (CL) data might cause the structure interference. In this report, the positions and postures of the machine structure where the structure interference may occur are calculated, and the tool path generation method considering the above-mentioned problem was developed. As the result of the machining simulation, the effectiveness of the devised technique was actually confirmed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of International Conference on Leading Edge Manufacturing in 21st century : LEM21
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
