Abstract
This paper proposes a method to find a transformation matrix in component mode synthesis. The accurate transformation matrix gives prediction mating with the measured dynamic characteristics of large space structures. In this proposed method, the transformation matrix is obtained from both internal and boundary modes of the components. These modes are measured in modal testing for each substructure attached with additional mass and additional stiffness at substructure interface. The proposed method is applied to a canti-lever beam to confirm that this method can give the dynamic characteristics of the beam. Numerical results show the effectiveness of the proposed method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.