Abstract
This study aims to investigate the influence on the basic cutting performances when changed the number of flutes in high speed end milling and to develop the new end mill for the high speed and high efficient machining. The hardened steel (SKD11 (HRC60)) and (Ti, Al) N coated carbide square end mill were used in this experiment, and tool wear and finished surface roughness were researched by side cutting under the dry cutting condition. The following results were obtained. 1) When cutting with the plural cutting edges simultaneously and cutting with a single cutting edge, those wear behavior was different. 2) The amount of the material removal to the tool life did not correspond to the ratio of the removal rate proportional to the number of flutes.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
