Abstract
The experiments for cold rolling of stainless steel and carbon steel sheets were made to measure the friction coefficient between rolls and a material, the surface characteristics of rolled sheets and the width spread ratio of sheets. Then, the effect of roll surface profiles on the friction coefficient and the characteristics of rolled steel sheets was discussed. As a result, it has been shown that the friction coefficient in cold rolling with rolls polished by #800 polishing paper in axial direction is smaller than that in circumferential direction, and that the friction coefficient in cold rolling decreases with increase of the ratio of flat area on rolled sheet surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.