11-th order of accuracy for numerical solution of 3-D Poisson equation with irregular interfaces on unfitted Cartesian meshes

Abstract

For the first time the optimal local truncation error method (OLTEM) with 125-point stencils and unfitted Cartesian meshes has been developed in the general 3-D case for the Poisson equation for heterogeneous materials with smooth irregular interfaces. The 125-point stencils equations that are similar to those for quadratic finite elements are used for OLTEM. The interface conditions for OLTEM are imposed as constraints at a small number of interface points and do not require the introduction of additional unknowns, i.e., the sparse structure of global discrete equations of OLTEM is the same for homogeneous and heterogeneous materials. The stencils coefficients of OLTEM are calculated by the minimization of the local truncation error of the stencil equations. These derivations include the use of the Poisson equation for the relationship between the different spatial derivatives. Such a procedure provides the maximum possible accuracy of the discrete equations of OLTEM. In contrast to known numerical techniques with quadratic elements and third order of accuracy on conforming and unfitted meshes, OLTEM with the 125-point stencils provides 11-th order of accuracy, i.e., an extremely large increase in accuracy by 8 orders for similar stencils. The numerical results show that OLTEM yields much more accurate results than high-order finite elements with much wider stencils. The increased numerical accuracy of OLTEM leads to an extremely large increase in computational efficiency.Also, a new post-processing procedure with the 125-point stencil has been developed for the calculation of the spatial derivatives of the primary function. The post-processing procedure includes the minimization of the local truncation error and the use of the Poisson equation. It is demonstrated that the use of the partial differential equation (PDE) for the 125-point stencils improves the accuracy of the spatial derivatives by 6 orders compared to post-processing without the use of PDE as in existing numerical techniques. At an accuracy of 0.1% for the spatial derivatives, OLTEM reduces the number of degrees of freedom by 900−4⋅106 times compared to quadratic finite elements. The developed post-processing procedure can be easily extended to unstructured meshes and can be independently used with existing post-processing techniques (e.g., with finite elements).