Abstract

A novel cell-immobilization technique was developed in this study for increasing substrate partition to the gel matrix by coating a polyurea thin layer on the surface of Ca-alginate beads. The proposed method was simple and could be performed under mild conditions. The bioconversion of progesterone to 11α;hydroxyprogesterone with these polyurea-coating alginate-entrapped Aspergillus ochraceus cells was investigated using different organic solvents in biphasic media. The reaction medium of ethyl acetate could markedly enhance the bioconversion rate with the existence of a hydrophobic layer, most likely resulting from the increasing partition of substrate to gel matrix. Bioconversion with higher substrate concentration was possible using an ethyl acetate-water medium. The conversion rate increased almost linearly with increasing substrate concentration from 10 to 80 g l −1. The rate with 80 g l −1 progesterone increased up to six times greater than the rate with the immobilized cells without coating, and also exhibited a much higher rate than that reported in the literature.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.