10.1063/5.0044367.2

Abstract

A flow simulation was performed for face shields to investigate whether varying a shield's edge shape could prevent droplets from entering the shield. Face shields with two types of edge shapes were used. The “Type I” shield had small plates mounted on the top and bottom edges of the shield to physically inhibit the sneeze inflow. The “Type II” shield had small brims sticking forward from the shield surface and small plates sticking upward and downward at the top and bottom edges to inhibit the entrainment flow produced by the vortex ring using sneeze flow. We confirmed that the flow characteristics around a face shield can be controlled using the shield's edge shape. In Type I, the entraining flow inside the shield was inhibited by the mounted small plate at the bottom edge, ensuring the inhibiting effect, but not at the top edge. In Type II, the entrained flow inside the shield was inhibited by the mounted brim and small plate at the top edge, ensuring the inhibiting effect, but not at the bottom edge. The effects of the Type II design parameters on the flow characteristics around the face shield were examined. The results indicate that at the top edge, increasing the length of the brim and not mounting the small plate at an incline from the shield surface improves the inhibition effect. At the bottom edge, shortening the length of the brim and mounting the small plate at an incline from the shield surface improves the inhibition effect.