Abstract
Organic/inorganic hybrid coating materials were synthesized using acrylate end-capped polyester, 1,6-hexanediolacrylate, tetraethoxysilane (TEOS), and 3-trimethoxysilylpropylmethacrylate (TMSPM). The hybrid materials were cast onto a polycarbonate (PC) substrate and cured by UV irradiation to give a hybrid film with covalent linkage between the inorganic and the organic networks. The coating layer was characterized by FT-IR and 29Si-NMR, and pencil hardness and oxygen permeation rate of coated films were investigated. The pencil hardness of all samples examined in this study was higher than 1H, whereas that of uncoated PC substrate was 6B. The hardness enhancement after coating may due to incorporation of organic acrylate resin. The oxygen permeability coefficient of the film coated with hybrid material on 3-aminopropyltriethoxysilane (APTEOS) pretreated polycarbonate substrate was 1.67×10−3 GPU, the lowest value in this work, whereas that of uncoated PC substrate was 8.07×10−3 GPU. The lower oxygen permeation rates of these films are attributed to the good adhesion between organic/inorganic hybrid coating layer and PC substrate and a dense structure induced by an increase of network density.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
