Abstract
Experiments were performed to investigate the effect of a line of roughness elements on flat-plate boundary layer transition. Each roughness element was a cylinder 2 mm in both diameter and height. Eleven elements formed a row in the spanwise direction. Wedge-shaped turbulent regions ("turbulence wedges") developed downstream from the respective roughness elements. Further downstream, two adjacent wedges merged together and then a two-dimensional turbulent boundary layer was formed. Mean and fluctuating velocities were measured by hot-wire anemometers. From the velocities an intermittency factor and turbulent dissipation, etc. were obtained. The manner how the three-dimensional turbulence wedges change into two-dimensional boundary layer were investigated. At first, the fluctuating velocity on the generator of roughness element and center between roughness elements overshot Spalart distribution. And further downstream, both distribution of fluctuating velocity undershot it.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Proceedings of the Fluids engineering conference
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
