Α Hybrid Device for Anchoring FRP Sheets Aimed to Enhance the Flexural Capacity of RC Elements

Abstract

Abstract: The potential of externally applied FRP (fiber-reinforced plastic) sheets, being employed in retrofitting schemes aimed to repair and strengthen RC (reinforced concrete) structural elements damaged by prototype strong earthquakes, is presented and discussed in this study. The limitation of the debonding mode of failure of these FRP sheets is highlighted and the necessity to develop efficient anchoring devices for these FRP sheets is underlined. The behavior of such a novel HAD (hybrid anchoring device), capable of anchoring CFRP (carbon fiber reinforcing plastic) sheets to RC structural elements, is presented and discussed. The behavior of the device itself was studied through a 3D non-linear numerical simulation at the preliminary design stage in order to establish certain desired features such as the ductile behavior of the device itself as well as the satisfactory performance of the FRP sheets wrapped around this device. This HAD was next applied as part of a strengthening scheme aimed to upgrade the flexural capacity of an RC bridge-type pier specimen subjected to a cyclic seismic-type loading sequence. The obtained results demonstrated an increase in the specimen’s flexural capacity by 100% as well as a similar increase in its capability of dissipating energy in a ductile manner during the cyclic load sequence. Moreover, the employed 3D non-linear numerical simulation yielded reasonably good agreement between the measured and the predicted cyclic response of this specimen strengthened by CFRP layers, which were anchored by the novel HAD. The successful behavior of this novel HAD, which has been patented with No. WO2011073696, is currently being tried with a number of other retrofitting schemes employing FRP sheets externally attached on RC structural elements.