Abstract
As increasing the number of Electronic Control Units in a vehicle, the proportion for reliability and stability of the software is going increasingly. Accordingly, the traditional CAN network has occurred the situation that the requirement of developing vehicle software is not sufficient. To solve these problems, the FlexRay network which is ensured the high bandwidth and real-time is generated. However it is difficult to implement FlexRay based application software because of complex protocol than traditional CAN network. Accordingly the system for analysis and verification of network state is needed. Also vehicle vendor develops application software using Matlab/Simulink in order to increase productivity. But this development method is hard to solve the network problem of node to node. Therefore this paper implements Matlab/Simulink based FlexRay network system and verifies it through comparing with existing embedded system.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
