Abstract
In order to repair and improve the performance of machinery parts of a power plant, pulsed Nd: YAG laser, CO2 laser, diode laser and TIG cladding were carried out for deposition of Stellite 6 alloy on the surface of 12%Cr martensitic stainless steel plate (t=12mm). These clad layers were characterized by investigating cross sectional geometry, microstructural features and DAS (Dendrite Arm Spacing) values, dilution, macro- and micro-distribution of alloying elements, primary and eutectic phases, hardness distribution and wear resistance by microscope, SEM, EDS, EPMA, X-ray diffractometer, Vickers hardness tester and Oogoshi wear resistance tester.The small dilution ratios, fine microstructures, narrow widths of heat-affected zones, high Vickers hardness, excellent wear-resistance, high contents of Co and low contents of Fe in the clad layers were obtained by laser cladding in comparison with TIG process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.