Abstract
Currently, plastic gear is widely used as parts of office equipment and industrial machines, because plastic substance has an advantage of light weight and possible to operate in oil-fewer conditions. However, under cyclic loadings, their occurred repetitive deformation due to weak tensile strength and bending stress rather than metal gear. Furthermore, they have a problem of attrition and breakage owing to frictional heat. For solving these problems, when plastic gear's opponents are metal gear, we should design that plastic gear's tooth be thick and metal gear's tooth be thin. In this research, we developed the program which developing tooth profile of non-standard gears automatically and calculating over-pin diameter for inspection after making gear.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Korea Society For Power System Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
