단형질 개체모형을 이용한 한우 육종가 추정프로그램 개발

Abstract

단형질 개체모형을 이용한 육종가 추정프로그램의 해를 구하는 컴퓨터 프로그램을 포트란 언어를 이용하여 자체개발하였고, 프로그램은 자료기반으로 반복적으로 계산을 해 나가는 간접법을 이용한 것으로 일반적인 알고리즘으로 프로그램을 개발하고 이의 효율을 개선한 개선알고리즘으로 프로그램을 개발하여, 두 프로그램 간 효율을 비교하였다. 기존의 전통적인 알고리즘은 순차적인 반복문을 이용하여 자료를 읽고 기록하는 방법이며, 새로운 알고리즘은 효과별로 LHS를 직접 작성하여 추정하는 방법을 사용하였다. 개발된 두 가지 프로그램으로 육종가를 추정하고, 그 추정 값이 정확하게 평가되었는지 알아보기 위하여 기존에 개발되어 사용되고 있는 BLUPF90 (Misztal, 2007)과 MTDFREML (Boldman 등, 1999)과 비교하여 보았다. 서로 다른 프로그램으로 추정된 육종가간의 상관은 전체 항목에서 99% 이상 고도의 상관이 나타났으며, 프로그램 추정치 간의 높은 상관으로 볼 때 Model I, Model II는 정확하게 개발되었고 평가된 것을 확인할 수 있었다. Solution이 수렴 될 때까지의 반복횟수는 Model I은 2,568 round, Model II는 1,038 round로 수렴되어 Model II가 Model I보다 작은 반복횟수에서 수렴이 된 것을 확인할 수 있었으며, 수렴속도는 Model I은 256.008초, Model II는 235.729초로 Model II가 Model I 보다 약 10% 정도 개선된 것을 확인할 수 있었다. 개발된 프로그램을 기존 D/B와 연계한다면 농가 및 지자체 등에 지속적인 개량 정보를 제공할 수 있으며, 농가 단위 암소 유전능력평가로 암소개량을 도모할 수 있을 것이라 사료된다. Estimate breeding value can be used as single trait animal model was developed directly using the Fortran language program. The program is based on data computed by using the indirect method repeatedly. The program develops a common algorithm and imprves efficiency. Algorithm efficiency was compared between the two programs. Estimated using the solution is easy to farm and brand the service, pedigree data base was associated with the development of an improved system. The existing program that uses the single trait animal model and the comparative analysis of efficiency is weak because the estimation of the solution and the conventional algorithm programmed through regular formulation involve many repetition; therefore, the newly developed algorithm was conducted to improve speed by reducing the repetition. Single trait animal model was used to analyze Gauss-Seidel iteration method, and the aforesaid two algorithms were compared thorough the mixed model equation which is used the most commonly in estimating the current breeding value by applying the procedures such as the preparation of information necessary for modelling, removal of duplicative data, verifying the parent information of based population in the pedigree data, and assigning sequential numbers, etc. The existing conventional algorithm is the method for reading and recording the data by utilizing the successive repetitive sentences, while new algorithm is the method for directly generating the left hand side for estimation based on effect. Two programs were developed to ensure the accurate evaluation. BLUPF90 and MTDFREML were compared using the estimated solution. In relation to the pearson and spearman correlation, the estimated breeding value correlation coefficients were highest among all traits over 99.5%. Depending on the breeding value of the high correlation in Model I and Model II, accurate evaluation can be found. The number of iteration to convergence was 2,568 in Model I and 1,038 in Model II. The speed of solving was 256.008 seconds in Model I and 235.729 seconds in Model II. Model II had a speed of approximately 10% more than Model I. Therefore, it is considered to be much more effective to analyze large data through the improved algorithm than the existing method. If the corresponding program is systemized and utilized for the consulting of farm and industrial services, it would make contribution to the early selection of individual, shorten the generation, and cultivation of superior groups, and help develop the Hanwoo industry further through the improvement of breeding value based enhancement, ultimately paving the way for the country to evolve into an advanced livestock country.