Abstract
Solder bumps have been used to interconnect the chip and substrate, and the size of the solder bump decreases below to accommodate higher packaging density. In order to fabricate solder bumps, a mold to chip transfer process is suggested in this work. Since the thin stainless steel mold is not wet by the solder, the molten solder is forced to fill the mold cavities with ultrasonic vibration. The solders within the mold cavities are transferred to the Cu pads on the polyimide film through reflow soldering.
Full Text 
Sign-in/Register to access full text options
Sign-in/Register to access full text options 
Published version (
Free)
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
