Физико-химические свойства наночастиц золота в рудах и катализаторах

Abstract

Introduction. At present, in the instrumental study of the mineral forms of finding gold in geogenic and technogenic ores, more and more attention has been paid to free gold, with a size of several nanometers. Such gold has been found in almost all types of its geogenic ores: starting with deposits of primary sulfide ores and ending with various gold-bearing placers. A similar situation is observed with technogenic gold-bearing ores accumulated in numerous dumps and tailings. At the same time, with the increase in research on nanogold, not only its fundamental, but also practical importance grows, because. in theoretical and applied research, more and more of its actual physical and chemical properties and previously unknown phenomena and effects accompanying them are discovered and clarified. Research methods and materials. An important aspect is the instrumental study of the geometry of various forms of nanogold occurrence in natural (geogenic) and technogenic ores and minerals. The instrumental and analytical part of our research was based on the visualization of nanoparticles obtained from the Nanjing Research Institute of the Chemical Industry under Sinopec (PRC), carried out on a JEOL 2010F microscope. Research results. The studied gold nanoparticles were presented in the form: • spherical fullerene-like monoparticles; • fullerene-like gold cells, consisting of a different number (from 13 to 20 clusters) of gold nanoparticles; • self-organized «fractal» dendrites; • rather complex composites with the participation of nanogold; • various aggregates of nanoparticles, etc. The concentrations of gold nanoparticles vary significantly from one deposit to another and between individual ore facies (even within the same deposit). Discussion of the obtained results. It was found that nanogold can be contained in arsenopyrites in 2 main forms: a) as a structurally bound solid solution (Au + 1) located in the lattice of this mineral; b) in separate mineral inclusions of submicron size or nanoparticles. Gold nanoparticles (5-10 nm in size) detected in arsenopyrite in concentrations up to 4% mass fraction are sufficiently representative to account for their amount in gold-bearing ores. A gold nanoparticle with a size of 3 nm usually has an average coordination number CN = 9.5, similar nanoparticles with a size of 1 nm have an average CN = 6, and nanoparticles with a size of 0.5–1 nm have an average CN = 3.6. Conclusion. To date, a nanoparticle catalyst has been developed in which gold clusters are attached to metal oxides that are semiconductors. At the same time, their number is very limited and includes only Fe2O3, TiO2, CeO2, and MgO compounds, which can be used not only in the form of nanoparticles, but also nanofilms. Such an innovative nanocatalyst ensures the efficient flow of a number of oxidative and other processes with hydrocarbons at normal temperatures, which is difficult to achieve by other methods. Findings. The article presents the results of studies of the physicochemical properties of gold nanoparticles installed in ores and catalysts. The morphology of gold nanoparticles has been established. The character of gold speciation in various sulfides is determined. The presence of gold nanoparticles in ores and rocks in the state of colloids has been confirmed. The catalytic activity of nanoparticles of various shapes and chemical states was revealed, depending on the values of the ambient temperature. The results of the research can be useful in the enrichment of gold-bearing ores of upland deposits.