Abstract

An equivalent drawbead model(EDM) for sheet metal forming analysis, which replaces complex drawbead geometries with drawbead forces in modeling the stamping dies with finite elements, is experimentally verified and applied to the numerical simulation of auto-panel stamping process. The drawbead restraining and opening forces of elliptical drawbead, circular drawbead, square drawbead, and step drawbead are obtained by performing the drawbead pulling test and compared with those of EDM and commercial code models(CCM). Better agreement with experimental measurements is found in EDM than CCM. Furthermore, the excellence of EDM is demonstrated in its application to the auto-body stamping analysis.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.