탄소나노튜브 표면 처리 실험실 종사자의 공기중 나노입자 노출에 관한 연구

Abstract

This study was performed to investigate laboratory workers' exposures to airborne nanoparticles at a university laboratory where acid treatment experiments were conducted on the surfaces of engineered carbon nanotubes (CNTs). The surface area concentrations, number concentrations, and mass concentrations of airborne nanoparticles were measured at personal breathing zones (PBZs) for various tasks using direct reading instruments. For all three metrics, airborne nanoparticle concentrations during the experiments were higher than background levels measured before and after the experiments for all three metrics. Among the various tasks that were performed as part of these experiments, one task that involved filtering a mixture of acid and CNTs showed the highest concentrations in all three metrics, with concentrations of /cc, 24320 pt/cc, and , respectively. Nanoparticle surface area concentrations measured at a representative area fluctuated with those at the PBZs in the laboratory. This result indicates that nanoparticles generated during the experiments were not just limited to the PBZs of the workers but were also present throughout the room, potentially exposing co-located workers. CNTs were detected by a transmission electron microscope in an air sample collected while handling the CNTs. All the tasks were performed inside fume hoods, with the sliding sashes open to their required heights. It was noted that the capture velocities of the fume hoods were much lower than the American National Standards Institute (ANSI)'s recommendation level (0.4 to 0.6 m/s). In conclusion, this study showed that, due to inadequate control, laboratory researchers performing acid treatment experiments on surfaces of CNTs were exposed to airborne nanoparticles generated during the tasks.