Abstract
This article presents the results of the effect of drawing speed on the rate of deformation and resistance to plastic deformation. When wire drawing on modern high speed wire drawing machines significantly increases the required amount of drawing dies. The influence of the technological parameters: speed drawing, half-angle of the die, wire diameter and a single strain on the rate of deformation of the metal. The influence of the technological parameters: speed drawing, half-angle of the die, wire diameter and a single strain on the rate of deformation of the metal. Found that increasing the resistance to drawing dies and achieve passport velocities drawing, when selecting process parameters drawing guided by the principle of uniform strain over the cross section of the wire by matching the single strain with half-angle dies and friction coefficient on the formula given in the article.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Russian Internet Journal of Industrial Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
