Abstract

The mechanical vibration often prevents from acheiving higher performance of an electromechanical control system which consists of closed loop electrical part and structural part. A new sensitivity analysis is developed in order to take account the amplitude and phase change of the total control system with respect to the mass or stiffness of the structural part. The modal analysis is used to determine the modal parameters of the structural part and then the servo analysis describes the closed loop characteristics. After identifying these parameters, the amplitude and phase sensitivity can be calculated in the function of frequency. A numerical simulation reveals that the proposed method can predict correct sensitivity. Then a simple electro-mechanical control system is manufactured and the sensitivity analysis is applied to confirm the effectiveness of the method.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.