Abstract
In this report, we propose a method to improve accuracy of concave large corner R by rough cut of a work piece where the corner R radius is greater than a half of cut groove width and the wire discharges symmetrically on whole front surface of the wire. In the control method, program path and discharge power are modified simultaneously at the corner R. The discharge power is adjusted so that difference between error of corner R on a middle surface and that on a top or a bottom surface of the work piece decreases within a allowable value. Program path is modified so that wire guides move along a path going a head of a desired corner R path, and the form of corner R on the top or the bottom surface of the work piece will be correct. The corner R radius is modified depending on the wire deflection.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of The Japan Society of Electrical Machining Engineers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.