Особенности расчета температуры резания при высокоскоростном фрезеровании алюминиевых сплавов без применения СОЖ

Abstract

Introduction. The calculation of temperature during high-speed milling of aluminum alloys is of interest, since temperature can act as one of the main limiting factors in choosing rational milling modes. This is especially important when milling thin-walled products used in aircraft construction, since its high values can lead to local warping of the structure. It is not possible to control the temperature factor in production conditions, which makes it necessary to develop a mathematical model for calculating temperature. The purpose of the work is to develop a methodology for predicting the cutting temperature during high-speed milling of aluminum alloy workpieces for cutting conditions, in which it is not possible to use cutting fluid. Methods. This paper presents experimental studies of the cutting temperature during high-speed milling of aluminum alloy workpieces without the use of cutting fluid using non-contact temperature measurement methods. The results obtained were used to determine the coefficients substituted into formulas for calculating temperatures on the front and back surfaces of the cutting blade. Results and discussions. Based on the results of experimental tests and theoretical modeling, a temperature graph is drawn up. A comparison of experimental studies of milling of aluminum alloy D16T, with changing cutting conditions (the cutting speed changed) with theoretical data, gave a satisfactory result. The average relative error when comparing experimental data with theoretical one is 6.05 %. Based on experimental data, it can be concluded that the comparison of experimental data for measuring cutting temperatures is in satisfactory agreement with the proposed method of theoretical calculation of temperatures. The advantage of this technique is that it allows, without time-consuming and costly experimental studies, theoretically calculate (forecast) the temperatures on the front and back surfaces of the cutting blade, as well as the cutting temperature, for those narrow milling conditions, where effective heat removal from the cutting zone is impossible. It can also be used for milling aluminum alloys, the mechanical and thermophysical properties of which differ.