Abstract
High speed face milling for plain carbon steel S 45 C was carried out with ceramic tools. TiC added alumina, and zirconia toughened alumina ceramic tools were mainly used. Among the tested ceramic tools, the zirconia toughened alumina ceramic tool showed the largest crater wear resistance in high speed face milling. However, in turning the same steel, the crater wear resistance of the ceramic tool was almost the same degree as compared to the other ceramic tools. The superior wear resistance of the zirconia toughened alumina ceramic tool is based on its stability for the reaction with Fe0 at high temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Japan Society for Precision Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
