Abstract
In this paper, the landing experiment of the Solar Panel Cleaning Robot(Dr.SPC) by a drone is presented. The robot arm for a drone (RAD) is designed to have two degrees-of-freedom to carry the cleaning mobile robot. The end-effector of the arm is equipped with an electromagnet to hold and release the robot electrically. The end-effector of the robot arm also has two ultrasonic sensors to measure the slanted angle of the panel and a camera to see the panel closely. Measuring the slanted angle of a solar panel is used for the arm to tilt the cleaning robot in parallel with the panel to minimize the contact force measured by a force sensor mounted on the first link. A drone is replaced with an x-y table for the planar motion of the arm. Actual landing experiments of Dr. SPC on the panel are conducted to test the feasibility.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: The transactions of The Korean Institute of Electrical Engineers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.