Abstract
Tooth Bearing is commonly used for hypoid gear pair inspection. Usually, in the inspection, hyipoid gear pairs are qualitatively evaluated by OK / NG. However, in order to conduct a follow-up survey on bad quality of products, quantitative evaluation of tooth bearing could be effective. For this purpose, the tooth bearing is inspected and evaluated by the experienced technicians. In the present study, a computer evaluation system for tooth bearing of hypoid gear pair has been developed. It is based on the nueral net, and enables the results of the inspections to be evaluated instead of the experienced technicians. The present paper describes the comparison of system evaluations with the technitian's ones. As a result, the evaluation performance of the developed system was greatly affected by quality of tooth bearings which are used for teacher signals.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Proceedings of the Symposium on Motion and Power Transmission
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
