Abstract
In this paper, tensile tests were carried out to investigate strength of oblique crossing joint by fillet weld. The results of macro tests explain that inadequate penetration of fillet weld occurred at the acute side of welds because of the small oblique angle. The results of tensile tests explain as follows ; 1) The failure of joint often occurred at the obtuse side of welds. 2) Failure angle of welds disagrees with the angles of those minimum throat thicknesses. 3) The strength of fillet weld decreases with smaller oblique angle.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Structural and Construction Engineering (Transactions of AIJ)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
