Year-end Sale % OFF 
Abstract
In grinding, it is required to clarify the processing phenomenon and the process to be made intelligent. The acquisition of detailed tool information is necessary for the purposes. Consequently, not a small number of measurements for wheel working face has been reported. This measurement is expected to be high-speed and performed on the machine. However, there is no measuring system, which is suitable for these purposes. Therefore, this paper describes a high-speed 3-D measuring system for wheel working face on the machine. In this system, a sensing head similar to a laser displacement meter is used. The sensing head is attached to grinding head by two automatic stages. The wheel rotating at 30m/s peripheral speed is scanned by these stages. The scanning resolution is 3μm for X, Y, and Z respectively. This system essentially does not have any limitation for the measurement area. The results of measurements are studied experimentally. As a result, the data obtained by this system is in good agreement with that by a laser microscope.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of the Japan Society for Precision Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
