赤外線ふく射方式陶材焼成炉に関する研究 第４報 金属・陶材の経時的温度上昇傾向について

Abstract

The porcelain sintering on “Technomat” is considered to start from the metalceramic interface and proceeds to the surface of porcelain.The purpose of this study is to compare the thermal rising character of metal-ceramic specimen on “Technomat” and conventional furnace.A metal specimen without porcelain and a specimen with 0.5mm opaque and 2.5mm body porcelain powder, were arranged on the tray in each muffle. Three thermal couples (1.0mm wide, 0.15mm thick, CA thermal couple JIS) were set into the specimens (one thermal couple on the metal: 1 channel, one into the metal-ceramic interface: 2 channel and one into the body porcelain powder: 3 channel respectively).Normal firing procedure of each furnace was executed, while each thermal couple's change in temperature was recorded on Data Collector AM 7001 (Anritsu Co.). And we obtained the follwing results.1. On “Technomat” the temperature at the metal-ceramics interface (2 CH) during firing procedure was always higher than that of porcelain powder (3 CH) at the same time.2. As for the conventional furnace “Ace”, the temperature of metal (1 CH) and porcelain powder (3 CH) generally coincide during firing procedure. The temperature of metal cerami interface (2 CH) was always lower than that of porcelain powder (3 CH).3. Measurement of the metal-ceramic specimen's change in temperature during firing procedure revealed the differences of the heating character between two furnaces.