Abstract
The analysis of the prospects for the use of basalt plastics in various industries has been carried out. The types of cutting tools used for machining PCM based on basalt fiber were studied. The results of mechanical processing of samples of basalt plastics by an end mill made of high-speed steel R6AM5, using a machine with numerical control in various modes (with varying tool speed and cutting speed) without and with the use of a lubricating coolant (coolant) are presented. The results of assessing the quality of cut surfaces based on their microanalysis performed using an optical microscope are presented. The optimal modes of cutting basalt plastic up to 3 mm thick with a high-speed steel end mill were determined. The analysis results of the absorption of cutting fluid by basalt plastic after mechanical processing are given. It was established that the best quality of the cut surface was achieved with the use of a coolant and reduced processing modes or without the use of a coolant and increased processing modes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
