Abstract
Effect of gamma-irradiation on the strength properties of various paperboards and corrugated fiberboards with different grades and effect of recycling on those irradiated sheets were investigated.Results obtained are summarized as follows : 1) Postradiational changes in the strength properties of AA-, A- and C-grade linerboards showed approximately same tendency.2) After 25 kGy irradiation (usual sterilizing dosage), AA- and A-grade liner boards reduced the ranking to A- and B-grade respectively, however, C-grade liner and A-grade medium remained in each grade.3) Corrugated fiberboard composed of AA-liner and A-medium remained the rank of S-4 (JIS Z 1516) even after 25 kGy irradiation. Corrugated fiberboard composed of A-liner and A -medium also remained the rank of S-3 after 25 kGy irradiation.4) Canadian standard freeness of recycled stock from the irradiated samples decreased with increasing dosage, and the increase of short fiber fractions by the irradiation was observed.5) The strength properties of handsheets recycled from the irradiated samples were lower than those from unirradiated samples except the wet tensile strength. Lowering degree of the strength properties was given in the following order : Folding endurance>Tearing>Bursting>Dry tensile.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.