ОПРЕДЕЛЕНИЕ КОНСТРУКТИВНЫХ ПАРАМЕТРОВ СТУПЕНЧАТОЙ ДИСКОВОЙ МЕЛЬНИЦЫ

Abstract

The calculation of the design parameters of a disc mill equipped with a feeder made in the form of a conical hopper is given. For shredders of the disintegrator type, it is very important to ensure the uniformity of loading of the crushed material of the working zone of active impact on particles. In addition, the most important factor is the throughput capacity of all sections of the grinding plant. The throughput should be determined by the design and technological parameters of the working chamber of the mill. Its overload can lead to a blockage of the working chamber, and insufficient throughput will negatively affect the intensity and effectiveness of the impact on the particles of the material. For example, insufficient concentration of particles in the secondary zone of the grinding chamber leads to a decrease in the efficiency of mutual abrasion. The article attempts to determine the design and technological parameters in the loading and accelerating parts of the disk mill. At the same time, it is necessary to coordinate the throughput of the disk spreader and the volumetric flow rate of the material particles flowing from the hopper. In this case, it is advisable to take into account that as a result of a rather high rotational speed and the size of the initial particles, with the wrong height of the radial blade of the spreader, material particles can roll over the radial blades, which leads to a delay of the material in the zone of the spreading disc. Therefore, it is necessary to determine the calculation formulas for finding the required height of the radial blade of the spreading disc, depending on the size of the initial particles. The formula demonstrates that the height of the separating blade depends on the particle size, the speed of rotation of the disks and the distance to the point of meeting of the particle with the radial blade.